The holoenzyme of yeast DNA polymerase ϵ (Pol ϵ) consists of four subunits: Pol2, Dpb2, Dpb3, and Dpb4. A protease-sensitive site results in an N-terminal proteolytic fragment of Pol2, called Pol2core, that consists of the catalytic core of Pol ϵ and retains both polymerase and exonuclease activities. Pre-steady-state kinetics showed that the exonuclease rates on single-stranded, double-stranded, and mismatched DNA were comparable between Pol ϵ and Pol2core. Single-turnover pre-steady-state kinetics also showed that the kpol of Pol ϵ and Pol2core were comparable when preloading the polymerase onto the primer-template before adding Mg(2+) and dTTP. However, a global fit of the data over six sequential nucleotide incorporations revealed that the overall polymerization rate and processivity were higher for Pol ϵ than for Pol2core. The largest difference between Pol ϵ and Pol2core was observed when challenged for the formation of a ternary complex and incorporation of the first nucleotide. Pol ϵ needed less than 1 s to incorporate a nucleotide, but several seconds passed before Pol2core incorporated detectable levels of the first nucleotide. We conclude that the accessory subunits and the C terminus of Pol2 do not influence the catalytic rate of Pol ϵ but facilitate the loading and incorporation of the first nucleotide by Pol ϵ.

• PMID: 25538242
• DOI full text
• PMC full text
• PubMed
• PubTator

Reference Type

Journal Article | Research Support, Non-U.S. Gov't

Authors

Ganai RA, Osterman P, Johansson E

Primary Lit For

Additional Lit For

Review For